Kurze Frage / kurze Antwort / kurze Information.

Hallo Dan

Im Anhang die Belegung des Sicherungskastens.
Ich habe mir auch eine heizbare Sitzauflage von Gonser besorgt. Funktioniert sehr gut. Mit einem warmen Fudi fährt es sich einfach besser.

Danke @eja, aber die Frage ist mehr, welche Sicherung wahrscheinlich überhaupt in Frage käme... wie ich auf die schnelle merkte, sind diese relativ mühsam so rauszuziehen.

Dan schrieb: Danke @eja, aber die Frage ist mehr, welche Sicherung wahrscheinlich überhaupt in Frage käme... wie ich auf die schnelle merkte, sind diese relativ mühsam so rauszuziehen.

Ein kleines Spitzzangerl wirkt Wunder!

Ich würde auf die Diagnose/Radioanschluss tippen, oder die 7,5A KFZ-Dose.
Wenn die Powerbox keinen Strom hat, läuft dein Twizy nicht mehr.

super, das ist die Antwort die ich suchte
Werde morgen diese überprüfen... die E-Heizung wird in Zukunft über eine andere unabhängige Batterie gefuttert.

Weiß zufällig jemand wie viel die Originalembleme für vorne und hinten kosten?

Does anyone have a broken charger lying around and can give me the piece of cable (connector included) that goes to the battery (traction and 12V) and the bus connector that is screwed onto the metal case of the charger?
I need these to do some experiments with an alternative charger.
See the photo to better understand the material I need.

I have a Twiz'O'Meter which sends its data to my Home Assistant over wifi. This only works when I'm driving (via my phone's wifi hotspot) and when it's parked next to my house (over my home wifi). What I want is to have it connected 24/7, so that I can see the charging process, etc. I took an old phone, put in a prepaid SIM with a couple of Gb of data, and connected it to a 30.000 mAh powerbank.

This works in principle... but the power bank is draining much faster than I expected. I have the power bank connected to the phone charger in the 12V socket, but the amount of time I drive is not enough to keep the powerbank charged, and I don't want to take it out every coupe of days to charge it. Obviously I can't connect it to the Twizy's 12V battery directly, that would surely drain it in short order.

Question: The Twizy usually is connected to 240V enough hours per week to keen the powerbank charged. Is it easy to safely tap into the Twizy's 240V power supply somewhere, so that I can install a normal phone charger, and keep the power bank charged that way? Where could I do this?

You better Not mess with the 220v system. I expect, your Twizy is Made 2020, so the Charger will Recharge the 12v Batterie If the voltage Drops. So use it and charge via 12v

My seatbelt is broken. This morning on my way to work it worked normally. When I drove home, I could pull out the seatbelt and click it in normally, but somewhere in the first minute of the drive I noticed it was "stuck", I couldn't lean forward. So, at a traffic light, I unclicked the seatbelt, and moved it towards the stored position, expecting the "lock" would release, and I could click in the belt normally. However, I could only move it up, and now it is in the fully stored position but completely stuck.

Has anyone experienced this? I still need to look at it, but home duties (cooking, kids, etc) first. I might be able to take a look at it tonight, but it's going to be in the dark, with a working light I hope it's easy to fix, I think this is the first time in 40+ years since I've been in a moving car without a seatbelt. Last time must have been on the backseat of my parent's car which didn't have seat belts on the rear seats...

Possibly “just” dirt in the roll-on/off mechanism.

You can remove the small cover Just below the hole. It is only hold in with 3-4 Clips. Then Clean with compressed Air and a little Bit of Oil on the Metal parts

Removing the roll-up unit was easy, but blowing air into it didn't help. I sprayed in a little WD40 at the sides, but no joy, still stuck.... I think I need to fully remove the seat belt, also the top hook and the seat attachment to take a good look under good light.



(I clearly didn't pay attention when I took the photo )

Quickly googling for a new unit, that's over € 100.

You know that the roll stucks in nearly every position.
It works only in the original Position.

The roll-up unit locks when it is not in a strait vertikal position. Check this point.